Sometime in your first week in the new house, you notice faded flags along the edge of the yard, or a small box on the garage wall with two wires running out through the siding. The sellers mentioned a dog fence. Nobody mentioned whether it works.
If you have a dog, you can often use it, or at least the part that cost the most to put in: the wire in the ground.
What sellers usually leave behind
When one of our customers moves, they almost always take the collars, and in our experience they take the transmitter roughly 60 percent of the time. The wire stays. Nobody digs up a boundary to take it to the next house.
So the most common inheritance is a wire around the yard with nothing connected to it, or a transmitter with no collar that fits your dog. Sometimes all of it is there, and sometimes it’s a few old flags and whatever the sellers remember.
Why the wire is worth checking
Burying the boundary is a big share of what a new system costs. Very roughly, on an average suburban half-acre lot, the wire and the work of putting it in run about a third of the total. On three acres with one dog it can be half or more, because there’s a lot more wire and only one collar.
If the loop is intact and runs where you want it, you may only need what goes on the wall and on the dog. Pet Stop equipment can often run on wire another company installed, so the brand on the transmitter matters less than whether the wire is sound and laid out the way you want.
Check the wire before you buy anything
If a transmitter came with the house, plug it in. Most transmitters warn you with a light or an alarm when the loop is broken, so a transmitter that powers up normally is a good first sign. It isn’t proof: a complete loop can still run somewhere you don’t want it, or under a patio that went in after the fence did.
If there’s no transmitter, the loop has to be tested with equipment, and finding where it runs takes a wire locator. That’s a service call, the same one we run for a broken wire. Our service page explains how we find and fix breaks in existing wire, including wire another company put in.
The questions worth answering before you decide anything:
- Is the loop complete?
- Where does it actually run?
- Does it give the dog the part of the yard you want the dog to have?
- Does it keep the dog out of anything inside the yard, like a pool or a garden, and do you want that?
- Has anything been dug, built or paved over it since it went in?
If it’s an Invisible Fence system
If the system is an Invisible Fence installation, you have two reasonable paths. You can keep the existing equipment, have it serviced and get collars that work with it, or you can keep the wire and put Pet Stop equipment on it. Our compatibility page covers both ways to keep the Invisible Fence equipment or put new equipment on the old wire.
The same thinking applies to other professionally installed brands. Photos of the transmitter, its labels and anything else the sellers left help us identify what you have before anyone comes out.
If the sellers were our customers
I’ve been doing this in the Birmingham area since 1994, and we have customers at more than 1,300 addresses in Mountain Brook and more than 1,000 in Hoover. A lot of the wire in Birmingham-area yards is ours. If you think yours might be, send us the address and we’ll check what we have on file for that house.
The collar the sellers left
If a collar stayed with the house, treat it as a part to identify, not something to put on your dog. It was fitted and set for another dog, and it only works with a transmitter that matches it. Fit matters more than most people expect: the most common reason we see a trained dog get out is a collar that has worked loose. Have it checked and set up for your dog before it goes on.
Training your dog on the new yard
If your dog used an electric dog fence at your last house, it already knows the important part. GentleSteps training doesn’t teach a dog where the boundary is. It teaches the dog to turn away from the warning tone wherever it hears it, and that carries over to a new yard, so moving a trained dog to a new property is usually straightforward.
It still gets a proper introduction. Every dog we train starts at the gentlest level, including dogs that have done this before, and we watch how the dog reacts before going any further. A dog that has never worn a collar starts the same way. GentleSteps training is available on its own, without a new installation; here’s how GentleSteps training works.
Before you dig
New owners tend to change a yard fast, and new beds, drainage work, a fence or a pool can cut a dog fence wire. Alabama 811 marks lines that belong to its member utilities. It won’t mark a private dog fence wire, so if you plan to keep the system, find out where the wire runs before anyone digs. Our page on how utility locates work covers what 811 handles when we install.
What to do, in order
- Find out what came with the house: wire, transmitter, collars, flags and any paperwork. Take photos.
- Have the wire tested and its route confirmed before you buy equipment or change the yard.
- Decide what to keep: the existing equipment, new equipment on the old wire, or a new layout.
- Train your dog to the system before you trust it with the yard. Don’t put a collar on the dog to see what happens.
Getting help
Already a Pet Stop customer? If you moved and want us to look at the system at your new house, request a service visit. It goes on your existing account instead of starting a new customer record.
New to Pet Stop of Alabama? Get an Estimate and tell us there’s already a system on the property. Include the address, whatever the sellers told you and what you found. You don’t need to know the brand.
Frequently asked questions
Can Pet Stop use dog fence wire another company installed?
Often, yes. If the loop is intact and laid out the way you want, Pet Stop equipment can often run on it. We test the wire before anyone counts on it.
Is an old dog fence worth keeping?
Often the wire is. Very roughly, on a half-acre suburban lot the wire and its installation are about a third of what a new system costs, and on large lots it can be half or more. Whether the transmitter and collars are worth keeping depends on their age and condition.
Can I use the Invisible Fence collar the previous owner left?
Only after it’s checked. It has to match the transmitter, fit your dog and be set for your dog. If you keep the Invisible Fence transmitter, compatible collars are available.
Does my dog need training if it used a dog fence at our old house?
Yes, and it usually goes quickly. Training teaches the dog to turn away from the warning tone, not to remember a particular yard, so it carries over. We still start at the gentlest level and watch how the dog reacts.
Will Alabama 811 mark the old dog fence wire?
No. 811 marks lines owned by its member utilities. A dog fence wire is private, so it has to be located separately before anyone digs near it.
Pet Stop of Alabama is an independent authorized Pet Stop® dealer and is not affiliated with, endorsed by, or sponsored by any other brand named on this page. Brand names are used only to identify equipment we service.